BGS technic 9072 Manual De Instrucciones página 16

REMOVAL
Remove the engine timing belt cover.
Note: The timing belt cover retaining bolts are different lengths.
Take note of the location of each bolt upon removal, ensuring that
the same length bolt is used when the engine is reassembled.
Loosely position correct one tool (1) on to the
Inlet camshaft and the other tool (1) on to the
Exhaust camshaft. Tighten locking screws of the
camshaft tools finger tight only, ensuring that the
camshaft tools are positioned correctly on the
camshafts. Secure the camshaft tools to the
cylinder head by tightening the 8 retaining bolts
to 10 Nm.
Depress the belt tensioner, releasing tension from the timing belt.
Lock the belt tensioner in position using (5). Remove and discard
the used timing belt.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed