BGS technic 9072 Manual De Instrucciones página 19

Remove all tools from the engine
Rotate crankshaft 1 & 3 turns in normal turns direction of engine
rotation.
Refit tool (3). Rotate the crankshaft in normal direction of rotation
until the crankshaft contacts (3).
INSTALLATION
Refit tool (6) to check that the pulley is position to check
correctly.
Note: An incorrectly positioned crankshaft pulley may
trigger a fault code in the engine management system.
Remove (6).
Remove the tool (3) and refit the crankshaft blanking
plug.
Refit the starter motor and refit the driveshaft bracket if
removed, using new driveshaft retaining clamps and
bolts.
Refit the alternator, air condition pump, auxiliary belt
tensioner and a new auxiliary belt.
Refit vehicle under shield and inner wing cover.
Ensure that the mating faces of the cylinder head,
engine front cover and camshaft cover are clean and
that the seals are free from dirt / foreign objects.
Apply a 5 mm bead of sealant to the cylinder head at
the joint between the cylinder head and the timing belt
cover. Also apply a 4 mm bead of sealant to the area at
the base of the fuel pump support block to prevent oil
leakage.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed