Publicidad
Idiomas disponibles
Idiomas disponibles
Bringing into use
Protect yourself with suitable
personal protective equipment (PPE) of wear-
ing eye protection, respiratory protection,
appro priate protective clothing, water-proof
gloves and boots from hazardous substances.
Only mixing and filling outdoors or in well-ven-
tiled greenhouse.
Attaching the spray tube
(Fig. B–E)
Attach the conical nozzle
double conical nozzle
to pressure control valve
26
nozzle in a clockwise direction.
Attached the pressure regulating value
the union nut
on spray tube
21
the union nut
.
21
Insert the spray tube
handle
, then tighten with the union nut
15
Connect the hose
13
dle
, tighten the union nut
15
Tighten the union nut
tion.
Fasten the lid of air chamber
goes.
Attach the belt hook
27
Adjust the length of belts
buckles
and move the belt pads
29
suitable carrying position.
Note: adjust in the same way before wearing
to give even load.
Note: The device must worn as close to the
body as possible and parallel to the spine.
Filling the pressure
sprayer tank (Fig. F)
Only mixing and filling outdoors
or in well-ventiled greenhouse.
Check the volume application rate when filling
the liquid into the sprayer.
Note: Before using the product, check to see
that it is in good condition and free of defects.
24 GB/IE
, fan nozzle
,
23
24
or four-hole nozzle
25
. Fasten the
22
to
22
. Tighten
20
into the spray tube
20
.
16
to the spray tube han-
.
14
in a clockwise direc-
12
as far as it
11
to belt hook holder
.
5
with the belt
30
for
28
Click the spray tube
on the spray tube
20
holder
(s. fig. I).
9
Unscrew the lid of container
wise direction and open.
Now fill the tank with prepared mixture
through the filter screen
31
Filter screen
is for filtering the solid substance.
31
Note: Fill the tank with only the amount of
liquid that you actually need for that particular
spraying session (not more than 16 l).
Note safety instructions on the labels of the
spraying pesticides used. Pay attention to the
stated max. concentrated.
Always request a safety data sheet from the
spraying agent manufacturer.
Place the lid of container
container
and fasten in a clockwise direc-
3
tion clockwise as far as it will go.
Changing of chemicals
Pls. follow the step of "Emptying the pressure
sprayer and disposal of spray solution" de-
scribed in the manual
Pls. follow the step of "Cleaning and care"
described in the manual .
Check the product according to the "Before
use" described in manual.
Pls. follow the step of "Filling the pressure
sprayer tank" described in manual.
Building up the
operating pressure (Fig. G)
General the pressure through the pump
by moving lever handle
6
and down until the pressure sprayer has been
pumped up to a pressure not exceeding the
maximum permissible operating pressure of
4 bar.
When carrying the tank
3
cess, can generate the pressure by moving
the levels handle
on levers
6
down with left hand if the pressure in the
tank
becomes low.
3
in an anti-clock-
1
carefully.
back onto the
1
10
on levers
up
7
with spraying pro-
up and
7
Publicidad
