Publicidad
Idiomas disponibles
Idiomas disponibles
Spraying
Carry the pressure sprayer over your shoulder
by the carrying belts
.
30
Note: Ensure that the pressure sprayer is
always kept upright. Only when held in this
orientation will the sprayer work properly.
Hold the spray tube handle
hand and direct the spray nozzle
or
e.g. at a plant.
26
Press the trigger
to start the spraying process.
17
Note (Fig. H): For continues spraying, move
the spray lock
backward. To release con-
18
tinues spray, move the spray lock
Release the trigger
to stop the spraying
17
process.
Note: When the pressure in the container
is no longer sufficient to spray, pump the con-
tainer
to increase the pressure again up to
3
but not exceeding the maximum permissible
operating pressure of 4 bar (see "Building up
the operating pressure").
Clip the spray tube
on spray tube holder
20
during work interruptions and breaks.
Note (Fig. I): The nozzle
always on the top position when the spray tube
is clipped onto the spray tube holder
20
After spraying, loosen the union nut
remove the spray tube
20
container
, move the spray tube handle
1
toward into the opening of tank
spray trigger
to release the residual pres-
17
sure above the opening of tank
residue spray solution, pls. follow the step of
"Emptying the pressure sprayer and Disposal
of spray solution" described in the manual.
Emptying the pressure sprayer
and disposal of spray solution
Always release residual pressure
before transport and cleaning. Protect yourself
with suitable personal protective equipment
(PPE) from hazardous substances. Take pre-
cautions to avoid environmental contamination
from hazardous substances.
firmly by the
15
,
,
23
24
25
toward.
18
3
9
,
,
,
23
24
25
26
.
9
and
16
. Open the lid of
15
, press the
3
. For the
3
Loosen the union nut
and remove the
16
spray tube
.
20
Open the lid of container
tube handle
toward into the opening of
15
tank
,
3
Press the spray trigger
17
ual pressure above the opening of tank
Remove any leftover spray product from the
tank and the pipes and store it in a suitable
container.
Do not dispose of residues down the drain.
Dispose shall follow the safety introduction
according to the chemical manufacturer.
Always keep the product away
from other people during emptying and dis-
posal.
Transport of the
pressure sprayer
Protect yourself with suitable
personal protective equipment (PPE) of wear-
ing eye protection, respiratory protection,
appro priate protective clothing, water-proof
gloves and boots from hazardous substances.
Only mixing and filling outdoors or in well-
ventiled greenhouse.
Make sure to release pressure
& empty the container
before transportation.
3
Either to transport the device in person or in
vehicles, please follow the steps:
Secure the product against falling, overturn,
vibration, extremely high or low temperatures,
direct sunlight and impacts during transportation
to avoid damages.
Tighten the sprayer with lid and all the union
nuts during transport to prevent loss of fuel,
damage or injury.
Always click the spray tube
tube holder
(s. fig. I) for transport or storage.
9
Note: Make sure that the pressure sprayer is
always in an upright position.
If transport in vehicles, please make sure the
device is put on flat surface to prevent falling.
, move the spray
1
to release the resid-
.
3
onto the spray
20
GB/IE
25
Publicidad
