Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
If the measures listed below are not successful,
contact the manufacturer.
= Fault
= Potential causes
= Remedies
No pressure is established
in the tank.
The lid of container
1
into place.
Fasten the lid of container
place.
Fasten the union nut
12
into place.
The piston
may have been damaged
35
Replace the piston
35
included spare parts " described in manual.
Split pin
fetch way
32
Re-tight the split pin
32
Spray nozzle does not spray.
No pressure present.
Generate pressure through the pump
moving the lever handle
The spray nozzle is blocked.
Stop use, unpressured, take care about pesti-
cide to person and environment. Clean the
spray nozzle
,
,
23
24
step of "Cleaning and care" section described
in the manual).
No spray in the tank.
Fill with spray.
Filter
is blocked.
19
Clean the filter with brush (please refer to the
"Cleaning and care" section).
The seal-ring loose or is damaged.
Re-tighten up or replace.
Rock Lever
is too heavy to operate.
7
Levers
is too tight.
7
Check and adjust the levers
Pump charmer
insufficiently lubricated.
10
Apply lubricant.
Nozzle
,
,
,
23
24
25
26
is not firmly fastened
firmly into
1
,
,
and
firmly
14
16
21
according to " Replace
on the product properly.
by
10
.
6
,
(Pls follow the
25
26
.
7
or filter
is blocked.
19
Stop use, unpressured, take care about pesti-
cide to person and environment. Clean with
brush (please refer to the "Cleaning and care"
section).
Pump is block.
Check the position of lever
Pls. contact its service agent or similarly quali-
fied persons. Failure to do so may result in
hazard.
Exchange of spare
parts included
Protect yourself with suitable
personal protective equipment (PPE) of wearing
eye protection, respiratory protection, appro priate
protective clothing, water-proof gloves and boots
from hazardous substances.
Only use spare parts and ac-
cessories provided by the manufacturer. All other
repairs shall only be carried out by the manufacturer,
its service agent or similarly qualified persons. Haz-
ards can arise due to improper maintenance (Fig. M).
After any replacement, pls. put
all parts back together and check the product
before use.
If found damaged with following part
no. replace with the spare parts included
in the package
Remove the damaged
Lever handle
8
holder for lever handle
8
and replace.
Seal washer sheet
Loosen the nozzel cap
ø 16 mm
34
23a
the damaged seal washer
sheet ø 16 mm
replace.
and split pin
.
7
32
from the holder
9
,
or
, remove
24a
25a
and
34
GB/IE
27
Publicidad
