melitta Caffeo Lattea F300-100 Manual De Instrucciones página 62

10 Function settings
10.1 Water hardness
Use the test strip provided to determine the water hardness in your area. Please
comply with the instructions on the test strip packaging. Water hardness is set at 4
in the factory. If you have inserted the Melitta
is set automatically (see page 53).
Prerequisite: The appliance must be ready for operation (see „Switching on
and off" on page 52).
To maintain appliance quality, please adjust the water hardness as follows:
• Simultaneously press the button for one-cup dispensing
button for two-cup dispensing
→ The standby symbol
• Press the button for one-cup dispensing
for adjusting the water hardness.
→ The symbol for the water filter
• Press the button for coffee strength
the four possible degrees of water hardness.
→ Your water hardness selection according to the table is shown with the bean
symbols
Water hardness range
1:
2:
3:
4:
Heft_Lattea_EU_2_3.indd 59
is flashing rapidly.
on the display.
Properties
soft
medium
hard
very hard
flashing
(factory setting)
Claris water filter, water hardness 1
® ®
for more than 2 seconds.
once to call up the menu
is illuminated.
several times to select among
°d
0 - 1 0 0 - 1 3
10 - 1 5 13 - 1 9
15 - 2 0 19 - 2 5
> 20 > 25
and the
°e °f
0 - 1 8
18-27
27-36
> 36
59
09.04.2014 14:04:20