melitta Caffeo Lattea F300-100 Manual De Instrucciones página 70

11.3 Integrated cleaning programme
The integrated cleaning programme removes residues, including coffee oil residues,
that cannot be eliminated by hand. It takes a total of approximately 15 minutes. The
cleaning symbol
Prerequisite: The appliance must be switched off (see „Switching on and off"
on page 52).
Caution!
–
Run the integrated cleaning programme every 2 months or after
approximately 200 brewed cups of coffee; at the latest, however, run the
programme when the symbol for cleaning
– Only use Melitta
These cleaning tabs are specifically designed for the Melitta
LATTEA
®
Run the integrated cleaning programme as follows:
1 Open up the flap of the water tank (Fig. A, no. 7) and pull the water tank
up and out of the appliance. Fill the water tank to the max. mark with
fresh tap water and reinsert it.
2 Simultaneously press both the button for one-cup dispensing
the ON/OFF button
→ The symbol for cleaning
The drip tray symbol
3 Empty the drip tray and coffee grounds container.
4 Reinsert the drip tray without the coffee grounds container and place
the coffee grounds container under the outlet.
Phase 1
During Phase 1, one bean symbol
→ First, two automatic rinsing processes are carried out. Afterward, the
standby symbol
5 Reach into the recess on the right side of the appliance (Fig. A, no. 14)
and pull off the cover to the right.
Heft_Lattea_EU_2_3.indd 67
flashes during the entire process.
cleaning tabs for fully automatic coffee makers.
®
. The use of other cleaning agents can damage the appliance.
for about 3 seconds.
flashes.
illuminates.
illuminates.
lights up on the display.
is shown on the display.
CAFFEO
® ®
and
67
09.04.2014 14:04:22