Publicidad
Idiomas disponibles
Idiomas disponibles
Preparation
Know your power head
Before attempting to use the power head,
familiarize yourself with all of its operating
features and safety requirements.
WARNING!
Do not allow familiarity with the tool to cause
carelessness. Remember that one careless
moment is enough to cause severe injury.
Before attempting to use any tool, be sure
to become familiar with all of the operating
features and safety instructions.
WARNING!
Do not attempt to modify this tool or create
accessories not recommended for use with
this tool. Any such alteration or modification
is misuse and could result in a hazardous
condition leading to possible serious personal
injury.
Assembly
WARNING!
Read and understand the entire Operator's
Manual for each optional attachment
used with this power head and follow all
warnings and instructions. Failure to follow all
instructions could result in electric shock, fire
and/or serious personal injury.
WARNING!
This 18V power head is designed to be used
only with the attachment models that are
specified in this Operator's Manual. Use of
other, unauthorized attachments could cause
serious personal injuries or property damage.
WARNING!
Some accessories have specific requirements
related to safety. Always pay special attention
to such instructions in the manual that
accompanies each accessory.
WARNING!
Never install, remove, or adjust any
attachment while the power head is running
or with the battery installed. Failure to stop
the motor and remove the battery can cause
serious personal injury. NEVER OPERATE THE
POWER HEAD WITHOUT AN ATTACHMENT.
12
WARNING!
Always remove the battery pack from the
product when you are assembling parts,
making adjustments, cleaning, or when the
product is not in use.
Installing/removing the power
head attachment
To install the attachment
a)
Stop the motor and remove the battery
pack.
b)
Loosen the wing knob (1) (see Fig B).
c)
The power head has two grooves on the
coupler (2), ONLY the groove( B-2) is used
to connect attachment: GLT 35.
d)
Align the spring-loaded pin (C-2) on the
attachment with the groove (C-1) on the
coupler (2) and push the attachment
shaft into the power head shaft until the
pin pops out of the groove and you hear
an audible "click" sound at the same time
(see Fig C).
e)
Pull the shaft of the attachment to verify
that it is securely locked into the coupler (2).
f)
Tighten the wing knob (1) securely.
To remove the attachment (See Fig D)
a)
Stop the motor and remove the battery
pack.
b)
Loosen the wing knob.
c)
Press down the spring-loaded pin
(D-1), with the pin pressed, pull or twist
the attachment shaft out of the coupler.
Mounting / adjusting the front-
assist handle
To mount the front-assist handle (see Fig E)
a)
Stop the motor and remove the battery
pack from the power head.
b)
Remove the screw knob (10) and the lock
lever (9) from the front-assist handle (8).
c)
Mount the front-assist handle (8) on the
shaft.
d)
Insert the lock lever (9) into the front-
assist handle (8), and then tighten the
screw knob (10). Make sure that the front-
assist handle (8) faces upwards so that it
points toward the rear handle.
e)
Lower the lock lever to secure the front-
assist handle onto the shaft so that
it cannot move on the shaft during
operation.
GPH 18-EC
Publicidad
