Flex GPH 18-EC Instrucciones De Funcionamiento Originales página 150

Technical data
Tool
Type
Cutting mechanism
No-load speed
Cutting-line type
Cutting width
Weight according to
"EPTA Procedure
01/2003"
Working temperature
Storage temperature
Overview (see figure A)
The numbering of the product features refers to
the illustration of the machine on the graphics
page.
1. Bump head
2. Cutting line
3. Trimmer head
4. Trimmer attachment shaft
5. Line-cutting blade
6. Guard
7. Hex key
8. Bolt (2)
9. Spring washer (2)
Preparation
Know your line trimmer
This product requires assembly. Carefully lift
the tool from the carton and place it on a level
work surface. Before attempting to use the
line trimmer attachment, familiarize yourself
with all of its operating features and safety
requirements.
WARNING!
■ Do not allow familiarity with the tool to
cause carelessness. Remember that one
careless moment is enough to cause severe
injury. Before attempting to use any tool,
be sure to become familiar with all of the
18
GLT 35
Line Trimmer
Bump head
/min 5500-6500
4m Φ2.4mm
twisted nylon line
cm 35
kg 1.7
-10~40°C
<50°C
operating features and safety instructions.
■ Do not attempt to modify this tool or
create accessories not recommended for
use with this tool. Any such alteration or
modification is misuse and could result in
a hazardous condition leading to possible
serious personal injury.
Assembly
WARNING!
This product requires assembly. To reduce
the risk of injury to persons, never operate
without the guard in place. The guard must
always be on the tool to protect the user.
Mounting the guard (See Fig
B&C)
■ Install the guard before the attachment is
connected to the power head.
■ To reduce the risk of injury to persons, do
not operate without guard in place.
a. Loosen the two bolts (8) in the guard
with the supplied hex key (7). Remove
the bolts and spring washers (9) from the
guard (6).
b. Lift the trimmer head (3) and face it
downward; align the two mounting
holes in the guard with the two assembly
holes in the base of the shaft. Make sure
that the inner surface of the guard faces
towards the trimmer head.
c. Use the supplied hex key to secure the
guard in place with the washers and
.
bolts
Connecting the line trimmer
attachment to the power head
GLT 35 18-EC
This line trimmer attachment is designed for
use with FLEX Power Head GLT 35 18-EC.
See "To install the attachment" section in
the power head GLT 35 18-EC operator's
manual.
GLT 35