Flex GPH 18-EC Instrucciones De Funcionamiento Originales página 153

GLT 35
e. Hold the spool base and rotate the bump
head in the direction indicated by the
arrow to wind the cutting line into the
trimmer head (See Fig M).
f. Push down on the bump head and check
for proper installation of the cutting line.
Transmission Gears Lubrication
(See Fig N)
The transmission gears in the gear case
(N-2) need be lubricated periodically with
gear grease. Check the gear case grease
level about every 50 hours of operation by
removing the sealing screw (N-1) on the side
of the case.
If no grease can be seen on the sides of the
gear, follow the steps below to fill with gear
grease up to 3/4 capacity.
Do not completely fill the transmission gear
case (N-2).
a. Hold the line trimmer attachment on its
side so that the sealing screw (N-1) is
facing upwards.
b. Use a multi-function wrench (not
included) to loosen and remove the
sealing screw (N-1).
c. Use a grease syringe (not included) to
inject some grease into the lubrication
opening, taking care not to exceed 3/4
capacity.
d. Tighten the sealing screw (N-1) after
injection.
Disposal information
WARNING!
Render redundant power tools unusable:
mains operated power tool by removing
the power cord,
battery operated power tool by removing
the battery.
EU countries only
Do not throw electric power tools into
the household waste!
In accordance with the European Directive
2012/19/EU on Waste Electrical and
Electronic Equipment and transposition into
national law used electric power tools must
be collected separately and recycled in an
environmentally friendly manner.
Raw material recovery instead of
waste disposal.
Device, accessories and packaging should
be recycled in an environmentally friendly
manner. Plastic parts are identified for
recycling according to material type.
WARNING!
Do not throw batteries into the household
waste, fire or water. Do not open used
batteries.
EU countries only:
In accordance with Directive 2006/66/EC
defective or used batteries must be recycled.
NOTE
Please ask your dealer about disposal
options!
-Declaration of conformity
We declare under our sole responsibility
that the product described under "Technical
specifications" conforms to the following
standards or normative documents:
EN 62841 in accordance with the
regulations of the directives 2014/30/EU,
2006/42/EG, 2011/65/EU.
Responsible for technical documents:
FLEX-Elektrowerkzeuge GmbH, R & D
Bahnhofstrasse 15, D-71711 Steinheim/Murr
Peter Lameli
Technical Director Head of Quality
08. 20.2023; FLEX-Elektrowerkzeuge GmbH
Bahnhofstrasse 15, D-71711 Steinheim/Murr
Klaus Peter Weinper
Department (QD)
21