Publicidad
Idiomas disponibles
Idiomas disponibles
Carefully align bottom pole section (3) into top pole section (1) as shown. Bounce sections together using a wood
8.
scrap, while maintaining alignment, until the top pole section (1) reaches the mark line on bottom pole section (3).
You must have a 5-1/2" (13.9 cm) overlap for proper assembly.
NOTE: IF A 5-1/2" (13.9 CM) OVERLAP WHICH ALLOWS THE HARDWARE TO BE ASSEMBLED IS NOT
ACHIEVED !! STOP !! DO NOT PROCEED TO THE NEXT STEP! - CALL SPALDING CUSTOMER SERVICE FOR
ASSISTANCE.
Secure the pole sections together using the bolt (36), washers (37), and nut (38).
When properly pounded together, the pole sections must have a 5-1/2" (13.9 cm) overlap. Failure
to have required overlap will cause the poles to be unstable and/or break, posing a risk of impact
injury. If the minimum overlap cannot be achieved, do not move forward with installation and call
Spalding customer service for assistance.
WARNING
Note orientation of poles during
assembly, and ensure faces
are aligned that will allow for
hardware insertion.
12
1
5-1/2"
(13.9 cm)
Line
3
3
NOTE
Wood Scrap
Publicidad
