Publicidad
Idiomas disponibles
Idiomas disponibles
Initial use
Assemble the product
Remove the packaging and assemble the product as shown in
Figure A.
Then insert the ground spike
(see Fig. A).
Installing the product (Fig. C)
Note: The product can be installed without a power source.
Only use the product with the included ground spike
Push the assembled product far enough into the ground (lawn,
flower bed) so it is stable (see Fig. C). Since the product relies on
sunlight, consider and observe the following points prior to instal-
lation.
1. Select a location where the solar module
sunlight during the day.
2. Position the product so the solar module
the shade (trees, roof ridge, etc.).
3. Be sure the solar module
source, e.g. yard or street lighting, as this will prevent the product
from switching on at dusk. Remember many light sources will only
switch on due to the time or movement during the night.
Preparing the product prior to initial use
Note: The product features a twilight sensor and an main switch
When fully charged the product on time is approx. 8 hours.
Press the main switch
before using it for the first time.
Place the product in the sun.
into the bottom of the product
2
is not impacted by another light
6
to switch position "I" to the switch on
5
.
2
is exposed to direct
6
is not covered or in
6
GB/IE
.
5
27
Publicidad
