Publicidad
Idiomas disponibles
Idiomas disponibles
Now again fasten the battery compartment cover
fastening screws
closing, pay attention to the silicone cover
protection is not guaranteed. Press the main switch
the product on during darkness.
For model E, F
Loosen the fastening screws
driver. Loosen the screws on the solar module
solar module
of a slot screwdriver. Pay attention to the wires. Lift up the circuit
board
very carefully and insert it again. Pay attention to the
11
groove in the solar module
Exchange the old rechargeable battery to a new one. Take care
to the correct polarity, when inserting the new rechargeable
battery
.
9
The polarity is indicated in the battery compartment.
The new rechargeable battery has to have the same technical
data like the old one (see "Technical data"). The rechargeable
battery must be kept as horizontal as possible when inserting it.
Now again fasten the LED
fasten the fastening screws
driver. When closing, pay attention to the silicone cover
wise the IP protection is not guaranteed.
Press the main switch
switching on during darkness.
Troubleshooting
Note: The product contains sensitive electronic components. Radio
transmitting equipment in the immediate vicinity may therefore cause
interference. These could be e.g. mobile phones, two-way radios, CB
by using a small cross head screwdriver. When
8
8
, LED
and solar panel
6
11
6
, solar panel
11
by using a small cross head screw-
8
to switch position "I" to enable the product
5
, otherwise the IP
7
by using a small cross head screw-
12
with the help
10
when inserting it again.
and solar module
10
, fasten the
3
to switch
5
then lever out the
6
, other-
7
GB/IE
29
,
Publicidad
