Publicidad
Idiomas disponibles
Idiomas disponibles
LIVARNO LUX LSLR 16 A1
1. Intended use
This LED emitter is not intended for commercial use. It is suitable for inside and outside use. The device
fulfils all relevant norms and standards relating to CE conformity. Any modifications to the LED emitter
other than recommended changes by the manufacturer may result in these standards no longer being met.
2. Package contents
LED emitter LIVARNO LUX LSLR 16 A1
Fitting materials (2 x screws and 2 x rawlplugs)
Operating instructions with safety instructions
These operating instructions have a fold-out cover. On the inside of the cover is a diagram of the LED
emitter with the components numbered (figures A to C). The meanings of the numbers are as follows:
Twist joint
1
Pitch joint
2
Reflector
3
Operating mode LED (covered)
4
Movement sensor
5
Screw
6
Mounting plate
7
Unlock button
8
Screw terminal
9
Power cable (not included in the package / domestic power lines)
10
Operating mode pushbutton
11
Screw (2 units, for wall-mounting) - no picture -
12
Rawlplug (2 units, for wall-mounting) - no picture -
13
20 - English
Publicidad
