LIVARNO LUX LSLR 16 A1 Manual De Instrucciones página 27

6.3 Before mounting
DANGER! The unit must only be mounted by an authorised electrical engineer! The power
supply must be via the building's electrical circuit.
DANGER! The power must be switched off during the mounting process!
DANGER! When drilling holes, make sure there are no cables in the walls.
 Before mounting the LED emitter, make sure you are familiar with all its individual parts and read and
observe the instructions and diagrams in these operating instructions.
 In particular, note the dimensions of the LED emitter:
 Make sure that the cable to which the LED emitter is to be connected is not live. To do this, remove the
fuse for the relevant power circuit or switch the circuit breaker to the "0" position in your fusebox.
 Make sure that you also test that the cable is not live using a voltage tester!
LIVARNO LUX LSLR 16 A1
English - 25