Publicidad
Idiomas disponibles
Idiomas disponibles
MODEL DESCRIPTION
All Models
Hatco Split Drawer Warmers are built of rugged stainless steel
with heavy-duty full extension drawer slides and heavy-duty
hardware. These models are free-standing units equipped with
two, three, or four drawers, 64 mm (2-1/2") deep food pans for
each drawer, 102 mm (4") legs, and an attached 1829 mm (6')
power cord with plug.
Each drawer features an adjustable temperature control
and temperature monitor. Drawers can be configured with
or without drawer vents. A single Power I/O (on/off) switch
controls the power to the unit. The insulated top and sides
provide maximum energy efficiency and the blanket heating
elements are warranted for one year. All drawer slides are
warranted against breakage for two years.
MODEL DESIGNATION
Drawer Warmer
SPECIFICATIONS
Plug Configurations
Units are supplied from the factory with an electrical cord and
plug installed.
WARNING
ELECTRIC SHOCK HAZARD: Plug unit into a properly
grounded electrical receptacle of the correct voltage,
size, and plug configuration. If plug and receptacle do not
match, contact a qualified electrician to determine and
install proper voltage and size electrical receptacle.
NOTE: The specification label is located on the back of the
unit. See the label for serial number and verification of
unit electrical information.
H D W - x R 2
Heated
Drawer
Vents
POWER ON/OFF (I/O) Switch
Quantity of Reduced/Split Drawers
per Full Size HDW Drawer
Reduced/Split Drawer Unit
Quantity of Full Size HDW Drawers
(for size identification)
Schuko 7/7
Plug Configurations
NOTE: Receptacle not supplied by Hatco.
4
Temperature
Monitor
TEMPERATURE Control Knob
Model HDW-2R2
BS-1363
AS 3112
Form No. HDWR2CEM-0518
Publicidad
