Descargar Imprimir esta página

Nilfisk Advance SC351 Li-ion Instrucciones De Uso página 16

Ocultar thumbs Ver también para Advance SC351 Li-ion:

Publicidad

Idiomas disponibles

Idiomas disponibles

MACHINE START AND STOP
Starting the machine
1.
Prepare the machine as shown in the previous paragraph.
2.
Turn the function selection knob (31) to turn on the machine and select one of the programs according to the following table:
Position
Symbol
(32)
(33)
(34)
3.
Turn the solution flow control switch (36) to one of the following positions, according to the type of cleaning to be performed
One drop: to scrub/clean floors which are not very dirty; in this condition the machine can work with an autonomy of 50
minutes (0.25 litres/min average).
Two drops: to scrub/clean floors which are quite or very dirty; in this condition the machine can work with an autonomy of
25 minutes (0.5 litres/min average).
4.
While keeping the hands on the handlebar (2), start the machine by pressing the enabling push-button (38) together with the
brush levers (39).
NOTE
If the green warning light (37) turns on, the machine is ready to be used. If the red warning light turns on, the battery
must be charged (see the procedure in Maintenance chapter).
Stopping the machine
5.
Release the brush levers (39) and the enabling push-button (38).
6.
Turn the function selection knob (31) to "0" to turn off the machine.
MACHINE OPERATION (SCRUBBING/DRYING)
1.
Start the machine as shown in the previous paragraph.
2.
While keeping both hands on the handlebar (2), move the machine and start scrubbing/drying the floor .
3.
If necessary, adjust the solution quantity by using the switch (36).
4.
When necessary, to use the squeegee in the opposite direction, pry on the handlebar (2) and slightly lift the deck while the
brush is turning. When the deck is turned by 180° start to scrub/dry by drawing the machine.
To resume working in the normal forward direction, push the machine forward until the brush deck (12) returns to the original
position.
WARNING!
Pay attention when lifting the deck with the brush turning: The deck will suddenly turn by 180°. Pay attention to
the moving part, do not hit and/or damage things, walls or people.
CAUTION!
To avoid damaging the floor surface, do not use the brush without the solution and, when the machine is not
operating, stop the brush/pad-holder by releasing the levers (39).
CAUTION!
Before lifting the brush/pad, turn it off by releasing the levers (39).
INSTRUCTIONS FOR USE
Program
Scrubbing and drying.
Brush - vacuum system - solution flow activation
Scrubbing.
Brush - solution flow activation
Drying.
Brush - vacuum system activation
13
ENGLISH

Publicidad

loading

Este manual también es adecuado para:

50000622