Nilfisk Advance SC351 Li-ion Instrucciones De Uso página 19

AFTER USING THE MACHINE
After working, before leaving the machine:
1. Empty the tanks (23 and 22) as shown in the previous
paragraph.
2. Perform the daily maintenance procedures (see the
Maintenance chapter).
3. Store the machine in a clean and dry place, with the brush/
pad-holder and the squeegee blades lifted or removed.
MACHINE LONG INACTIVITY
If the machine is not going to be used for more than 30 days,
proceed as follows:
1. Perform the procedures described in the previous
paragraph.
2. Store the machine in a clean and dry place.
3. To safeguard the brush or squeegee blades, bend the
handlebar (2) forward and park the machine as shown in
figure 5.
MAINTENANCE
The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance. The following chart
provides the scheduled maintenance. The intervals shown may vary according to particular working conditions, which are to be
defined by the person in charge of the maintenance.
WARNING!
Maintenance procedures must be performed with the machine switched off and the battery/battery charger cable
disconnected.
Moreover, carefully read the instructions in the Safety chapter.
All scheduled or extraordinary maintenance procedures must be performed by qualified personnel, or by an authorised Service
Center. This Manual describes only the easier and most common maintenance procedures.
NOTE
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be
consulted at any Service Center.
SCHEDULED MAINTENANCE TABLE
Procedure
Battery charging
Squeegee Cleaning
Brush Cleaning
Tank and Vacuum Grid Cleaning
Squeegee blade check and/or replacement
Solution valve check and cleaning
Brush deck rotation clutch check and/or replacement
(1) For the relevant procedure, refer to the Service Manual.
INSTRUCTIONS FOR USE
Daily, after using
the machine
16
Figure 5
Every six
Weekly
months
(1)
ENGLISH
P100411
Yearly
(1)