FUSE CHECK/REPLACEMENT/RESET
(Just when the vacuum motor or brush
motor can't work normally)
1.
Drive the machine on a level floor.
2.
Check that the function selection knob (31) is
turned to "0".
3.
Open the cover (4) and loosen the screws on rear
battery box cover (8-1) to check one of the
following fuses for deactivation or integrity
(Fig. 9):
•
(A): F5(30 A) blade fuse, vacuum system motor.
•
(B): F4(30 A) blade fuse, brush motor.
Reset or replace any fuse, after having checked and
repaired any problem that caused deactivation.
4.
Lock the screws to close the outer cover and
close the cover (4).
INSTRUCTIONS FOR USE
B
A
20
ENGLISH
P100415
Figure 9