Publicidad
Idiomas disponibles
Idiomas disponibles
(4) Digital Display Ammeter
The set current is displayed during standby, and the actual current is displayed during welding.
(5)Digital Display Voltmeter
The set voltage is displayed during standby, and the actual voltage is displayed during welding.
(6) Plastic Case Front plastic frame
(7) Separate/synergic Option
Separate/synergic options, and the corresponding indicator lights.
- In the case of separate, the current and voltage are set separately;
- In the case of synergic, the voltage setting is linked with the existing current setting. First set the voltage knob at the center
indication position, and then adjust the current knob, so that the voltage will automatically match with the current adjustment.
It is available to adjust the voltage around the center position, and the voltage will change based on the default value.
(8) Selection of Work Mode
Two-step and four-step working modes optional, and the corresponding indicator lights.
- Two-step working mode: Suitable for short welding seam welding by pressing the torch switch to weld normally, and
releasing the switch to stop welding;
- Four-step working mode: Suitable for welding with long weld seams; after successfully starting the car by pressing the
torch switch, it is available to perform welding normally by releasing the switch. When pressing the torch switch again, it is
transferred to the arc welding specification set by the knob on the front panel, and the welding will stop when the switch is
released.
(9) Selection of Welding Wire Diameter
1.0, 1.2, 1.6 options in NB-500I welding power supply according to the diameter of welding wire, and the corresponding
indicator lights.
(10) Selection of Welding Mode
Options of flux core gas shielded welding, solid gas shielded welding and manual welding according to the welding mode,
and the corresponding indicator lights.
(11) The output terminal of welding power supply "+"
(12) Seven-core wire feeder control socket
This interface is used to connect the wire feeder.
(13) The output terminal of welding power supply "-"
(14) Junction Box
(15) Heating Socket
Connected the heating cable of the CO2 gas regulator with output voltage at AC36V.
KEEP WORKiNG
KEEP WORKiNG
Keep Working
12
S i
9 5 0 0
m P
Publicidad
