Publicidad
Idiomas disponibles
Idiomas disponibles
Position
Wire feeding hose
Gas Shunt
Wire feeder
Position
Handle
Wire Feeding Roller
Pressurizing Roller
KEEP WORKiNG
KEEP WORKiNG
Keep Working
Key points for overhaul
Damage to the heat shrinkable tube, wear of the O-
shaped ring.
Tube
shrinkable
Forget the insertion or holes are blocked, or the
assembly of components is purchased from other
manufacturers
Key points for overhaul
Whether the wire diameter is adjusted above the
pressurizing indication line. (Special note: it is strictly
forbidden to damage the wire below 1.2mm)
Whether the wire diameter and the nominal diameter
of wire feeding wheel are the same
Inspect and check if there is blocking in wire feeding
wheel.
Check the smoothness of rotation, the wear of the
welding surface of wire and the narrowing of contact
surface.
O-shaped ring
Rodillo de
presión
Rodillo de
alimentación
25
S i
9 5 0 0
Remarks
May cause splashing
The heat shrinkage is broken and
shall be changed into a new wire
feeding hose.
O-ring is worn and shall be
changed into a new one
May cause weld defects (splash,
etc.) due to poor gas protection, or
burning of the torch body (arc in
the body), etc., please handle
correctly
Remarks
Will cause unstable wire feeding
and arc
Cause the cut powder in welding
wire, blocking of the wire feeding
hose and the arc instability.
Please replace it with a new one
once an abnormality occurs
Cause poor wire feeding and even
unstable arc..
m P
Publicidad
