Publicidad
Idiomas disponibles
Idiomas disponibles
Preparaciones para soldadura con protección de gas
(1) Preparación del aparato de seguridad
- Asegúrese de usar guantes de cuero y botas de seguridad para proteger la piel del operador o las partes expuestas del
cuerpo.
- El filtro de sombreado se utilizará para proteger los ojos del operador y la selección del filtro óptico deberá seguir el
principio que se muestra en la tabla
Welding Current
Optical Proof
The welding place shall be equipped with fume removal equipment to prevent the operator from inhaling the harmful fume
and dust during welding.
(2) Switch operation and gas flow adjustment
- Turn on the power switch of the distribution box;
- Set the welding method on the welding power control panel to the option of "solid core" or "fluid core" gas shielded welding;
- Set the welding wire diameter and shielding gas on the control panel of the welding power supply at the needed position;
- Press the welding torch switch, turn on the gas cylinder switch, and adjust the gas regulator to make the value of the flow
meter meet welding; (refer to Table 10 Welding Examples)
- Press the torch switch again to stop the air supply.
(3) Welding wire installation
Be sure to carefully check the specification of the wire feed wheel complies with the diameter of the used welding wire, and
then install the welding wire
KEEP WORKiNG
KEEP WORKiNG
Keep Working
Less than 100A
No.09 - No.10
100A-300A
No.11 - No.12
16
S i
9 5 0 0
m P
Above 300A
No.13 - No.14
Publicidad
