Publicidad
Idiomas disponibles
Idiomas disponibles
Junta en ángulo (lámina)
Plate
Thickness
(mm)
1.6
2.3
3.2
4.5
8. MAINTENANCE AND TROUBLESHOOTING
Daily Maintenance
Routine maintenance is critical to fully utilize the performance of this unit and ensure safe operation. During routine
maintenance, the key point is to check whether the parts in welding torch and feeder
device are worn or deformed, and if the pores are clogged. The descaling and replacement of certain parts should be
performed when necessary. In order to maintain the original performance when replacing parts, be sure to use the authorized
parts of our welding machine.
Caution
- Unless there is special need, the overhaul must be carried out under safe condition by cutting off the power supply of
distribution cabinet.
- Failure to comply with the above principles may result in serious accidents related to personal safety, such as electric shock
and burns.
Welding power
Position
Control panel
Cooling fan
Power Source
KEEP WORKiNG
KEEP WORKiNG
Keep Working
Welding wire
Welding
diameter (mm)
current (A)
0.8 – 0.9
65～75
0.8 – 0.9
80～100
1.0 – 1.2
130～150
1.0 – 1.2
150～180
Key points for overhaul
Switch operation, conversion and installation. Verify
whether the power indicator is on or off
Check if there is wind and whether the sound is
normal
Whether there is abnormal vibration or buzzing when
powering on.
Whether there is odor when powering on Whether
there is heating trace in appearance, such as color
Welding
Welding speed
voltage (V)
16～17
19～20
20～22
21～23
International overhaul is available
for the condition without fan rotation
or abnormal sound
23
S i
9 5 0 0
Gas flow
(cm/min)
(l/min)
10
10～15
10
10～15
10～15
10～15
10～15
10～15
Remarks
m P
Publicidad
