Publicidad
Idiomas disponibles
Idiomas disponibles
(16) Air Switch
This switch is designed to automatically cut off the power when the welding power supply is overloaded or there is
malfunction, so as to protect the personal safety of users and important parts of the welding power supply. Generally, this
switch is moved up to the connected position. Be sure to use the power switch on the distribution board (cabinet) as much
as possible to start and stop the welding power supply. Do not use this switch as a power switch.
(17) Fan
Cool the heating components in the machine.
(18) Cable Clamp
(19) Grounding Mark
To ensure personal safety and normal use of the welding power supply, the ground wire in the input cable must be reliably
grounded.
(20) ClampTransfer switch
(21) Transfer switch safety cover
Wire Feeder Control Panel
(1) Current adjustment kno To adjust the welding current.
(2) Manual wire feed button Fast wire feeding.
(3) Voltage adjustment knob
- In the case of separate adjustment, it is used to adjust the welding voltage;
- In the case of unary adjustment, the knob indicator generally shall be adjusted to the "standard" position.
- The voltage can be fine-tuned by rotating left and right.
KEEP WORKiNG
KEEP WORKiNG
Keep Working
1
2
13
S i
9 5 0 0
m P
3
Publicidad
