Publicidad
Idiomas disponibles
Idiomas disponibles
EN
72
Fixing the indoor unit
1.
Hang the indoor unit on the peg
board, and move the unit from left
to right to ensure that the hook
is properly positioned in the peg
board.
2.
Push toward the lower left side
and the upper right side of the unit
toward the peg board, until the
hook is embedded in the slot and
makes a "click" sound.
Interconnection cord installation
1.
Open the panel, remove the screw on the wiring cover and then take down
the cover.
2.
Make the interconnection cord go through the cable-cross hole at the back of
indoor unit and then pull it out from the front side. (some models do not have
a signal cable).
3.
Remove the wire clip; connect the interconnection cord to the wiring
terminal according to the wiring diagram; tighten the screw and then fix the
interconnection cord with wire clip.
Wiring diagram
signal cable
panel
wiring cover
interconnection cord
screw
Publicidad
