1 To turn the blower On, press the
(2) and the desired speed button (3 or 4).
minimum button
2 To turn the blower Off, press the Blower On/Off button (2).
Any of the 3 blower speed buttons can be in the On position
at the same time. The blower will operate at the highest speed
button that is pushed in. For lower blower speeds, the higher
speed buttons must not be pushed in.
Maintenance
Cleaning
IMPORTANT: Clean the hood and grease filters frequently
according to the following instructions. Replace grease filter
before operating the hood.
Exterior surfaces
To avoid damage to the exterior surface, do not use steel wool
or soap-filled scouring pads.
Always wipe dry to avoid water marks
Cleaning method:
Liquid detergent soap and water, or all-purpose cleanser
•
Wipe with damp soft cloth or nonabrasive sponge, then
•
rinse with clean water and wipe dry.
Metal grease filter
The filters should be washed frequently. Place metal filters in
dishwasher or hot detergent solution to clean. Let filter dry
throughly before replacing it.
Turn off fan and lights. Allow lamps to cool.
1
Remove each filter by pulling the spring release handle
and then pulling down the filter.
A
2
Wash metal filters as needed in dishwasher or hot
detergent solution.
3
Reinstall the filter by making sure the spring release handles
are toward the front. Insert metal grease filter into upper
track.
4
Pull the spring release handle down.
5
Push up on metal filter and release handle to latch into place.
6
Repeat steps 1-5 for the other filter.
Replacing a LED lamp
The LED lights are replaceable by a service technician only.
See "Who to contact" section in the warranty for service
contact information.
Blower On/Off and speed
.
Available accessories
Carbon filter kit
If it is not possible to vent cooking fumes and vapors to the
outside, the range hood can be used in the non-vented ver-
sion, using a charcoal filter. Kit is available from the dealer or
an authorized parts distributor.
A
G
B
D
F
E
H
A.
Ceiling
B.
Vent cover
C.
Soffit
D.
6" (15.2 cm) vent
E.
Range hood
NOTE: 12" (30.5 cm) high cabinets without a soffit may allow
the 6" vent and vent cover to be seen.
Cover extension kit
To provide protection for the cabinet, a 30" and a 36" wide
cover extension is available.
NOTE: Kits are purchased separately (see optional accessories
section).
G
F
I
F.
Cabinet
G.
Wall
H.
12" (30.5 cm) min. cabinet height
I.
17" (43.2 cm) min. vent cover height
A
B
C
D
E
11