Publicidad
Idiomas disponibles
Idiomas disponibles
Bracket Orientation for 29.4"(74.8 cm) cabinet
B
A
A.
Cabinet
B.
Screws - 4.5 x 13 mm (8)
C.
Washers (optional)
D.
Mounting bracket (2)
Bracket Orientation for 36.7" (93.3cm) cabinet
C
A
B
D
Install range hood
I WARNING
EXCESSIVE WEIGHT HAZARD.
USE TWO OR MORE PEOPLE TO MOVE AND INSTALL
RANGE HOOD.FAILURE TO DO SO CAN RESULT IN BACK OR
OTHER INJURY.
1
Remove the polyurethane piece that comes inside the hood.
2
Center the canopy in the cabinet. Align the bottom of the
canopy with the bottom of the cabinet. Install four 4.2 x 19 mm
screws into the hood canopy assembly and tighten all (8)
mounting screws.
A
B
C
D
A.
Cabinet
B.
Screws - 4.5 x 13 mm (8)
C.
Washers (optional)
D.
Mounting bracket (2)
A.
Cabinet
B.
Hood liner canopy
assembly
C.
Screws - 4.2 x 19
mm (8)
C
Bracket position without spacers
Bracket position
with 1 spacer
6.35cm
3
Install the vent system according to the method needed.
Use caulking to seal the exterior wall or roof opening.
3
Remove the protective from the metal grease filters and
pull them out from the face panel.
4
Pull out the lamps connector cables
5
Attach the face plate to the hood insert. Tighten to secure.
NOTE: If cabinet depth is greater than 12", it is recommended
that the two .5" metal spacers are installed.
Install to front and rear sides of the face plate with 3.5 x 9.5 mm
screws as shown in drawing.
C
A
Center brackets
into the cabinet
Bracket position
with 2 spacers
7.7cm
7.6cm
Move the bracket .3" (1 cm) bot-
tom to top side of the cabinet
A.
Face Panel
B.
Front and rear spacer
C.
Screws - 3.5 x 9.5 mm (4)
C
B
9
Publicidad
