Publicidad
Idiomas disponibles
Idiomas disponibles
a) Do not overload the device. Use tools that are suitable for the application. A
correctly selected product will do a better and safer job for which it was
designed.
b) Do not use the device if the ON/OFF switch does not function properly (does
not turn on and off). Units that cannot be controlled by the switch are
unsafe, cannot operate, and must be repaired.
c)
Keep unused products out of the reach of children and anyone unfamiliar
with the device or this manual. Products are dangerous when used by
inexperienced users.
d) Keep the product in good working order. Check before each use for general
damage or damage to moving parts (cracks in parts and components or any
other condition that may affect the safe operation of the device). If damaged,
return the device for repair before use.
e) Repairs and maintenance should be carried out by qualified personnel using
only original spare parts. This will ensure the safety of use.
f)
To ensure the designed operational integrity of the device, do not remove
factory-installed covers or loosen screws.
g) When transporting or moving the device from storage to the place of use,
observe the health and safety rules for manual handling applicable in the
country where the device is used.
h) Avoid situations in which the device stops under heavy loads during
operation. This can cause overheating of the drive elements and consequent
damage to the equipment.
i)
Do not move, shift, or rotate the device while in operation.
j)
Do not leave the device switched on unattended.
k) Clean the device regularly to prevent permanent dirt build-up.
l)
The provided value of vibration emission is measured according to the
standard measurement methods. The value of vibration emission may
change if the unit is used under different environmental conditions.
m) Do not obstruct the air inlet or outlet.
n) Do not start up an empty unit.
o) Do not tamper with the device to alter its performance or design.
p) Keep the unit away from sources of fire and heat.
q) Do not overload the device.
r)
Do not block the ventilation openings of the unit!
s)
Add oil to the proper level before turning on the machine. If the oil level is
too low the engine will not start or may shut down.
t)
In case of any leakage of oils from the unit, you must report them to the
relevant services/authorities or observe the legal requirements in the area
where the unit is used.
EN
Publicidad
