Brush Replacement; Grinding Wheel - Festool RENOFIX RG 130 E Manual De Instrucciones

4
4a
4b
4-2
4-1
4-4
4-3

Brush replacement

After wear and tear of the brush [4-1], it must be
replaced.
f At first unscrew the screws with washers [4-2],
remove the brush from the cover [4-3] with the
springs [4-4].
f Insert the springs into the holes in the new
brush and secure the in the holes by turning
them clockwise – see figure [4 a]. Deflecting the
springs from vertical direction does not consti-
tute a defect.
f Then remove the brush with fitted springs, attach
them on the cover [4-3] from the front end and
tilt them – see figure [4 b].
f Make sure that the springs in the cover fit into
the guiding holes and screw back the screws
with washers [4-2].

Grinding wheel

Use solely wheels of Festool trademark, which
guarantees the grinding output of the machine –
see page 18.
f Backing flange [2-1].
15