Blackmagic Design ATEM Mini Manual De Instalación Y Funcionamiento página 25

and a knob for setting the left/right audio channel balance. The master fader on the right side of
the audio mixer is used to set the gain on the audio level on the USB webcam program output
and has its own audio level meter. Next to the master fader are mic faders which let you control
the audio level for microphones connected to the mic inputs.
The buttons below each audio level meter determine whether audio is always available for
mixing or only when the source is on air.
The solo monitoring feature for each input is greyed out as it supports ATEM Production Studio
and Broadcast Studio model switchers.
Tally
Any source whose audio is on air is lit with a red tally light in the software. In the example on
this page, camera 3 and camera 4 are lit because their audio is set to be always on. The tally
light will be illuminated dull yellow when AFV is selected and the channel's associated camera
is off air. This also applies to the master fader tally light when the master fader AFV button is
selected. When FTB is activated, the master fader tally light will blink red.
Audio Level
Drag the audio level fader to set the gain on the audio level for each camera and audio source.
The numbers under each audio level meter show the maximum audio level set by the fader.
The numbers above the audio meter show the peak audio level reached by the audio source.
A green number represents low to medium audio levels.
If the audio meter is regularly showing red, and the red number above it is not changing, then
you should reduce the audio level to avoid audio distortion. After adjusting the audio level, you
may wish to reset the red number by clicking on it once. Observe the new number to make sure
it changes for a while and does not immediately shoot up and become stuck on a red number.
If it does, you may need to reduce the audio level even further.
Audio Balance
The audio mixer supports stereo audio from each audio source. If you wish to change the left
and right audio channel balance for a camera or other audio source, adjust the knob to the
desired balance point.
Audio Source Selection
The audio meter for Cam1 is shown in
gray to indicate that its audio will not be
used as neither of its ON or AFV buttons
are enabled. Cam2 has AFV selected
but its audio is not currently being used
as the camera is not on air as is indicated
by its dull yellow tally light. Cam3 and
Cam4 have their direct mix set to ON
so their mixed audio is always used and
their tally lights remain lit, even if another
camera is currently on air. The audio
level meters for Mic 1 and Mic 2 show
that no audio is present on these inputs.
Using ATEM Software Control 25