Abicor Binzel TCS-FP Manual De Instrucciones página 50

6 Commissioning
1
Clamping device
2 Gas nozzle
Fig. 13 Setting up the pneumatic motor
 Fig. 3 Commissioning on page EN-12 and Fig. 13 Setting up the pneumatic motor on page EN-20
1 Loosen the motor clamp from the guide block (5) by removing the screws (3).
2 Pull back the pneumatic motor (4) in its mount.
3 Place the required distance sleeve (7) on the reamer (6).
4 Move the torch with the gas nozzle (2) to the clamping position (C).
5 Keep the guide block (5) in the lower position (down-stroke).
6 Place the pneumatic motor (4) against the gas nozzle (2) with the distance sleeve (7) placed on top.
7 Secure the adjusted motor position using the screws (3).
8 Move the torch out of the reamer holder (1) and remove the distance sleeve (7) from the reamer (6).
EN - 20
1
C
7
6
5
4
3 5
Screws
4 Pneumatic motor 6
2
3
7
Guide block Distance sleeve
Reamer
BAL.0713.0 • 2019-02-11
TCS-FP