Maintenance And Cleaning; Maintenance Intervals - Abicor Binzel TCS-FP Manual De Instrucciones

9 Maintenance and cleaning

9 Maintenance and cleaning
Scheduled maintenance and cleaning are prerequisites for a long service life and trouble-free operation.
The TCS-FP cleaning station is virtually maintenance free. However, it is in your interest to regularly clean and assess the
mechanically stressed parts in order to maintain the system's value and ensure it remains fully functional.
DANGER
Risk of injury due to unexpected start
The following instructions must be adhered to during all maintenance, servicing, assembly, disassembly and repair work:
• Switch off the power source.
• Close off the compressed air supply.
• Disconnect all electrical connections.
• Switch off the entire welding system.
DANGER
Electric shock
Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation and damage.
• Replace any damaged, deformed or worn parts.
NOTICE
• Only qualified personnel are permitted to perform work on the device or system.
• Always wear your personal protective equipment when performing maintenance and cleaning work.
The TCS-FP cleaning station is virtually maintenance free. However, it is in your interest to regularly clean and assess the
mechanically stressed parts in order to maintain the system's value and ensure it remains fully functional.

9.1 Maintenance intervals

NOTICE
• The specified maintenance intervals are standard values and refer to single-shift operation.
When using arc welding equipment, always observe the provisions of EN 60974-4 Inspection and testing, as well as any
national laws and regulations.
Check the following:
Weekly
• Check the condition of the reamer.
• Clean the clamping unit.
• Clean the injection unit.
• Clean the DAV wire cutter.
• Grease the DAV cutter guide after approx. 20,000 cuts.
• Empty the refuse container for wire scraps.
Tab. 15 Maintenance intervals
EN - 24
Monthly
• Monthly basic cleaning is recommended, and
necessary in case of extreme working conditions.
• Check the upstream maintenance unit's oil level and
ability to function correctly.
BAL.0713.0 • 2019-02-11
TCS-FP