Stihl SP 200 Manual De Instrucciones página 13

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English / USA
MAINTENANCE, REPAIR AND
STORING
Maintenance, replacement, or repair
of the emission control devices and
systems may be performed by any
nonroad engine repair establishment
or individual. However, if you make a
warranty claim for a component
which has not been serviced or
maintained properly or if
nonapproved replacement parts were
used, STIHL may deny coverage.
!
Warning!
Use only identical STIHL replacement
parts for maintenance and repair. Use of
non STIHL parts may cause serious or
fatal injury.
Strictly follow the maintenance and
repair instructions in the appropriate
section of your instruction manual.
Please refer to the maintenance chart in
this manual.
!
Warning!
Always stop the engine before doing any
maintenance or repair work or cleaning
the power tool. Do not attempt any
maintenance or repair work not
described in your instruction manual.
Have such work performed by your
STIHL servicing dealer only.
12
!
Warning!
Use the specified spark plug and make
sure it and the ignition lead are always
clean and in good condition. Always
press spark plug boot snugly onto spark
plug terminal of the proper size. (Note: If
terminal has detachable SAE adapter
nut, it must be attached.) A loose
connection between spark plug boot and
the ignition wire connector in the boot
may create arcing that could ignite
combustible fumes and cause a fire.
!
Warning!
Never test the ignition system with the
ignition wire boot removed from the
spark plug or with a removed spark plug,
since uncontained sparking may cause
a fire.
!
Warning
Do not operate your power tool if the
muffler is damaged, missing or modified.
In improperly maintained muffler will
increase the risk of fire and hearing loss.
If your muffler was equipped with a
spark-arresting screen to reduce the risk
of fire, never operate your power tool if
the screen is missing or damaged.
Remember that the risk of forest fires is
greater in hot or dry weather.
!
Warning!
Never repair damaged parts by welding,
straightening or modifying the shape.
This may cause them to break or come
off, resulting in loss of control and
serious or fatal injuries.
Tighten all nuts, bolts and screws,
except the carburetor adjustment
screws, after each use.
Store the power tool in a dry and high or
locked location out of reach of children.
Before storing for longer than a few
days, always empty the fuel tank. See
chapter "Storing the machine" in this
manual.
SP 200

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido