Fitting The Carrying Rings; Adjusting The Throttle Cable - Stihl SP 200 Manual De Instrucciones

English / USA

Fitting the Carrying Rings

1
2
6
5
4
3
Fitting Straps with Carrying Rings
: Attach one of the straps to the front
end of the drive tube (1) and the
other to the engine end of the drive
tube (2).
Do not wrap the strap around the
throttle cable.
3 Short strap
4 Long strap
5 Ring
6 Carrying ring
16
3
6
5
4
: Wrap the shorter strap (3) tightly
around the drive tube and close the
Velcro fastener.
: Thread the longer strap (4) through
the ring (5).
: Grip the end of the strap and pull it
tight.
: Hold the carrying ring (6) steady,
tighten the strap, wrap it around the
drive tube and close the Velcro
fastener.
Adjusting the Throttle
Cable*
A properly adjusted throttle cable is
the precondition for correct
operation in the full throttle, starting
throttle and idle positions.
Adjust the throttle cable only after
the unit is fully assembled – the
handle must be in the normal
operating position.
: Use a suitable tool to push the slide
to the bottom of the slot (see
illustration).
* see "Guide to Using this Manual"
SP 200