Activating Heart Rate Monitor From Power Saving Mode; Putting On The Heart Rate Monitor; Putting On The Chest Strap - Beurer PM 62 Manual De Instrucciones

6.2 Activating heart rate monitor from power saving mode

You can activate your heart rate monitor by pressing any button. If the
heart rate monitor has not received any signal for approx. five min-
utes, it switches to the power saving mode. At that point, only the
current time and the date will be displayed. Press any button in order
to reactivate the heart rate monitor.

6.3 Putting on the heart rate monitor

CAUTION:
Do not adjust the wristband too tight. You could get injured.
You can wear your heart rate monitor like a wrist watch. In order to fix
the heart rate monitor on bike handle bars, attach the bike mount
included to the handle bars. Tighten the heart rate monitor around the
mount such that it is not able to slip while riding.

6.4 Putting on the chest strap

Tighten the chest strap with the elastic tension
strap. Adjust the length of the elastic tension
strap such that the strap is snug, but neither
too loose nor too tight. Position the strap
around the chest such that the logo is facing
outwards and in the correct position directly
over the breast bone. For men, the chest
strap should be located directly below the
pectoral muscles, for women, directly below
the breast.
Since optimal contact between the skin and the heart rate sensors
can not be created immediately, it may take some time until the
heart rate is measured and displayed. If necessary, alter the posi-
tion of the transmitter in order to achieve optimal contact. Most of
the time, sufficient contact is achieved through the accumulation
of sweat beneath the chest strap. You can, however, also wet the
15