Water Resistance; General Operation Of The Hr Monitor; Buttons On The Hr Watch - Beurer PM 62 Manual De Instrucciones

contact points on the inside of the chest strap. For this, lift the
chest strap up from the skin slightly and wet the two sensors with
a little saliva or water or a conductive gel.
The contact between the skin and chest strap may not be inter-
rupted also with greater movements of the thorax such as during
deep breathing. Significant chest hair can interfere with and even
prevent contact.
Put on the chest strap a few minutes before starting in order to
warm it up to body temperature and establish optimal contact.

6.5 Water Resistance

NOTICE:
Do not jump into water (high pressure load) and press but-
tons in the rain or while in water. This might impair the im-
permeability of the monitor to moisture and therefore dam-
age the unit.
The PM62 is suitable for bathing and swimming.
Water Resistance = 98 ft. (30 m).
NOTE: The consistency of sea water, or chemicals used in a swim-
ming pool may impact the heart rate signal reception.
7. G
ENERAL OPERATION OF THE

7.1 Buttons on the HR watch

Starts and stops functions and adjusts values.
START/STOP
1
Press and holding accelerates the entry.
Switches between the functions within one
OPTION/SET
2
menu and confirms settings.
Switches between the different menus.
MENU
3
Pressing quickly illuminates the display for
/
4
five seconds. Pressing and holding acti-
vates/ deactivates the acoustic alarm when
exiting the training zone.
HR
MONITOR
16