Appendices; Trouble Shooting - Korg GRANDSTAGE 73 Manual De Usuario

3. Press the EDIT button once more to continue
loading.
Note:
If there is no USB storage device plugged into
the USB A port, the KORG/Grandstage directory
that was created when executing the "Save .FAV
File" function on this keyboard was not found, or
if there is no .FAV file located in that directory, the
message "No valid media" or "No File/Path" will be
shown on the third line of the display, and loading
will stop. If this happens, connect a USB storage
device to the Grandstage that contains the .FAV
file you saved, select "Load .FAV File" using the
VARIATION knob, and perform step 3.
4. The file to load is shown on the third line of the
display. If there is more than one file that can be
loaded, use the LEVEL knob to select the filename
to load.
5. Hold down the EDIT button for around one
second to load the data.
The words "OK?[Press EDIT]" will blink on the third line of
the display, to reconfirm that you wish to load the data.
Note:
To cancel the load operation, press the EXIT button.
This will go back to the "Select File" display.
6. Press the EDIT button quickly to begin loading
the data.
When loading is completed, the word "Completed" will be
shown on the third line of the display.
7. Press the SYSTEM or EXIT button to finish the
system settings.
20

Appendices

Trouble shooting

If the Grandstage does not function as you expect, check the
following points.
Power does not turn on
□ Is the power cord connected to an AC outlet?
□ Did you hold down the power button?
Power won't turn off
□ Did you hold down the power button for several seconds?
Power turns off
□ Could the Auto Power-Off function be enabled?
No sound when you play the keyboard
□ Is your powered monitor system or headphones connected to
the correct jack(s)?
□ Is the connected monitor system powered-on, and is the
volume raised?
□ Is the MASTER VOLUME knob set to a position where sound
will be output?
□ Is Local Control turned on?
□ Are the LEVEL knobs for each section turned all the way
down (to the left)?
□ Is the volume down on the pedal connected to the FOOT
CONTROLLERS PEDAL jack?
□ Are you exceeding the Grandstage's maximum polyphony
when you do not hear some sounds while playing?
The sound will not stop.
□ Are the settings for the damper pedal correct? Use the
Calibration function to adjust the polarity and half-damper
variable range of the pedal.
The sound seems to be doubled.
□ If you are using an external MIDI device or a DAW, check
whether the local control setting of the Grandstage is turned
OFF.
The sound is distorted.
□ Are the inputs of the mixer, powered monitor speakers and so
on being overloaded?
Use the MASTER VOLUME knob on the Grandstage to
adjust the output level, as well as the volume faders on the
mixer to adjust the input level gain.
Chords cannot be played on the keyboard.
□ On some programs such as monophonic synthesizer sounds,
you will not be able to play chords. This is not a malfunction.
The pitch doesn't sound right.
□ Is the Transpose function set correctly?
□ Are "Master Tune" in the system settings, as well as the
Octave and Tune edit parameters for the program set correctly?
The knobs and buttons on the panel won't respond.
□ Is panel lock on? (The EXIT (PANEL LOCK) button is
blinking in this case.)
The equalizer, dynamics and reverb/delay effects
don't sound, or I can't control them.
□ Is panel lock on? (EXIT (PANEL LOCK) is blinking in this
case.)
□ Are the DYNAMICS, EQUALIZER, or REVERB/DELAY
buttons off (dark)?