Recording - Sony MPK-DVF3 Manual De Instrucciones

Recording

Now you are ready for underwater recording.
When you dive with the camcorder, dive slowly, paying attention to the surrounding
environment. Be careful not to strike the marine pack against Rocks or Reef, etc.
POWER switch
AUTO FOCUS
ON/OFF button
REC lamp (red)
LEAK lamp
(yellow)
1
Set the POWER switch to ON.
The camcorder turns on and a picture appears on the LCD monitor.
2
Press the START/STOP button to start recording.
The REC lamp (red) lights up during recording.
To stop recording, press the START/STOP button again.
To zoom
Press the ZOOM button.
Press T for telephoto (subject appears closer) and W for wide-angle (subject appears
further away). You cannot change the zooming speed of the camcorder.
Recording a still image on a tape (Tape photo recording)
(DCR-TRV6E/TRV8E/TRV9E/TRV10E/TRV11E/TRV20E/TRV890E/
TRV900E only)
To record a still image, press the PHOTO button. The still image appearing on the LCD
screen is recorded. Note that pressing the PHOTO button lightly does not allow you to
check the recorded image. The memory photo function does not work on the DCR-
TRV10E/TRV11E/TRV20E/TRV900E models. For more details, refer to the operation
instructions supplied with your camcorder.
To keep a subject in focus
Press the AUTO FOCUS ON/OFF button to set it to OFF. You can still keep the subject
in focus even if fish swim between the camcorder and the subject. Press the AUTO
FOCUS ON/OFF button again to set the camcorder to auto focus mode.
Note
Do not cover the control emitter or detector with your finger as the remote control
signal for operations is transmitted from the grip to the marine pack.
ZOOM button
PHOTO button
START/STOP
button
continued
GB
13
-GB