Making Multimeter Measurements; Measuring Resistance Values; Making A Diode Measurement - Promax OS-782 Manual Del Usuario

USER'S MANUAL. OS-782
5.4

Making Multimeter Measurements

Press DMM/OSC key, the oscilloscope will switch to the multimeter measure, the
screen will display the multimeter windows, at the same time, prompt to correctly insert
testing pen of the multimeter, at this time, then press any key to enter into multimeter
measure.

5.4.1 Measuring Resistance Values

To measure a resistance, do the following:
1. Press the R key and R appears at the top of the screen.
2. Insert the black lead into the COM banana jack input and the red lead into the
V/Ω banana jack input.
3. Connect the red and black test leads to the resistor. The resistor value
readings are shown on the screen in Ohm. Now, you can see a screen that
looks like the following figure 34.

5.4.2 Making a Diode Measurement.

To make a measurement on the diode, do the following:
1. Press the R key and R appears at the top of the screen.
2. Press AUTO SET key once and the following is displayed on the screen
.
Page 51
Figure 34.- Measure resístance.
02-2010