Safety Rules; General - Promax OS-782 Manual Del Usuario

USER'S MANUAL. OS-782

2 SAFETY RULES

2.1

General

*
Only use this equipment as OSCILLOSCOPE in systems with their negative of
measurement connected to no-dangerous voltages with respect to the ground
potential.
*
Only use the equipment as MULTIMETER in points with a maximum potential of
400 V with respect to the ground potential and over voltage category CAT II.
*
This equipment can be used in Overvoltage Category II installations and Pollution
Degree 2 environments.
The adapter of net can be used only in interiors.
*
When using some of the following accessories use only the specified ones to
ensure safety
Power adapter.
Test leads (Multimeter)
Measurement probes (Oscilloscope)
*
The negative of measurement like Osciloscope is common to the negative
potential of the conector of input / output of information.
*
El negative of measurement of the channels of the osciloscopio is common.
*
On having effected measurements to disconnect the cables that are not in use.
*
Revise the condition of test leads before the utilization.
*
Observe all specified ratings both of supply and measurement.
*
Remember that voltages higher than 70 V DC or 33 V AC rms are dangerous.
*
Use this instrument under the specified environmental conditions.
*
The user not authorized to carry out the following maintenance operations.
Any change on the equipment should be carrier out byqualified personnel.
*
Do not obstruct the ventilation system.
*
Follow the cleaning instructions described in the Maintenance paragraph.
Page 7 02-2010