Assembly; Install Wheel Kit; Carton Contents - Briggs & Stratton ELITE Serie 030241 Instrucciones De Uso

Briggs & Stratton Generac Generator Discount Parts Call 606-678-9623 or 606-561-4983

ASSEMBLY

Your generator requires some assembly and is ready for
use after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your
generator, please call the generator helpline at
1-800-743-4115. If calling for assistance, please have the
model, revision, and serial number from the data tag
available. See "Features and Controls" for data tag location.
Unpack the Generator
1. Set the carton on a rigid flat surface.
2. Remove everything from carton except generator.
3. Open carton completely by cutting each corner from
top to bottom.
4. Leave generator on carton to install wheel kit.

Carton Contents

Check all contents against those listed below:
• Main unit
• Engine oil
• Operator's manual
Figure 1 — Install Wheel Kit
Hex Nut
Handle Assembly
Use existing hardware
to attach left side of
support leg to unit
Vibration Mount
Cap Screw
Hex Nut
Support Leg
Cap Screw
www.mymowerparts.com
ASSEMBLY
• Engine operator's manual
• Wheel kit
If any parts are missing or damaged, call the generator
helpline at 1-800-743-4115.

Install Wheel Kit

NOTE: Wheel kit is not intended for over-the-road use.
You will need the following tools to install these
components:
• 2 - 13mm and 7/16" wrenches
• Socket wrench with 13mm and 7/16" sockets
• Pliers
• Safety glasses
Refer to Figure 1 and install the wheel kit as follows:
1. Tip generator so that engine end is up.
2. Slide axle through both mounting brackets.
3. Place a wheel on each side with raised hub inboard.
4. Place a washer on axle and then place an e-ring in axle
groove.
5. Install e-ring with pliers, squeezing from top of e-ring
to bottom of axle.
Axle
Cap Screw
Hex Nut
6
Wheel
Flat Washer
E-Ring