Lithium-Ion Batteries - Bosch Dremel GO Instrucciones De Funcionamiento

1600A019PE.qxp_Go 5/24/18 3:13 PM Page 5
charger or tool is observed, unplug the charger
immediately and do not use the tool or charger.
Contact customer service immediately.
Make sure cord is located so that it will not
be stepped on, tripped over, or otherwise
subjected to damage or stress. Damaged
plug and cord may result in electric shock or
fire.
Disconnect the charger by pulling the plug
rather than the cord. Do not operate
charger with damaged cord or plug; have
them replaced immediately. Damaged plug
or cord may result in electric shock or fire.
Do not disassemble charger or operate the
charger if it has received a sharp blow,
been dropped or otherwise damaged in
anyway. Incorrect reassembly or damage may
result in electric shock or fire.
Before each use, check the battery charger,
cable and plug. If damage is detected, do
not use the battery charger. Never open the
battery charger yourself, take it to a Dremel
Factory Service Center, or qualified
serviceman only using original spare parts.
Incorrect reassembly may result in electric
shock or fire.
Do not use attachments not recommended
or sold by Dremel. Using attachments not
recommended may result in electric shock or
fire.
Unplug tool from charger when battery in
tool is fully charged. Tool left plugged in the
charger over a long period of time could lead to
tool damage and fire.
Unplug charger from outlet before storage,
attempting any maintenance or cleaning.
Such preventive safety measures reduce the
risk of electric shock or fire.
Keep the battery charger clean by blowing
compressed air on charger vents and
wiping the charger housing with a damp
cloth. Contamination may result in electric
shock or fire.
Replace battery pack if a substantial drop
in operating time per charge is observed.
Battery pack may be nearing the end of its life.
Battery Care
When batteries are not in tool or charger,
keep them away from metal objects. For
example, to protect terminals from shorting
DO NOT place batteries in a tool box or
pocket with nails, screws, keys, etc. Fire or
injury may result.
DO NOT PUT BATTERIES INTO FIRE OR
EXPOSE TO HIGH HEAT. They may
explode.
Battery leakage may occur under extreme
usage or temperature conditions. Avoid
contact with skin and eyes. The battery
liquid is caustic and could cause chemical
burn to tissues. If liquid comes in contact with
skin, wash quickly with soap and water. If the
liquid contacts your eyes, flush them with
water for a minimum of 10 minutes and seek
medical attention.
Battery Disposal
Do
disassemble the tool or
remove any component projecting from
the tool. Fire or injury may result. Prior to
disposal, protect exposed terminals with
heavy insulating tape to prevent shorting.

Lithium-Ion Batteries

If equipped with a lithium-ion battery, the battery
must be collected, recycled or disposed of in
an environ mentally sound manner.
"The EPA certified RBRC
Battery Recycling Seal on the
lithium-ion (Li-ion) battery
indicates Robert Bosch Tool
Corporation is voluntarily
participating in an industry
program to collect and recycle these batteries
at the end of their useful life, when taken out
of service in the United States or Canada. The
RBRC program provides a convenient
alterative to placing used Li-ion batteries into
the trash or the munici pal waste stream, which
may be illegal in your area.
Please call 1-800-8-BATTERY for information
on Li-ion battery recycling and disposal
bans/restrictions in your area, or return your
batteries to a Bosch/Dremel Service Center
for recycling. Robert Bosch Tool Corporation's
involvement in this program is part of our
commitment to preserving our environment
and conserving our natural resources."
Do not open the tool or
attempt
battery from your tool. Dispose of tool
through your local waste removal authority or
a Bosch/Dremel Service Center.
-5-
not attempt to
to remove