Meter-Feet Changeover (M/Ft); Secondary Reflector - Metz MECABLITZ 58 AF-2 digital Manual De Instrucciones

Ocultar thumbs Ver también para MECABLITZ 58 AF-2 digital:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 186

7.8 Meter-Feet changeover (m/ft)

The maximum flash range indicated by the flash unit's display can either be
shown in meters or feet. The setting can be adjusted under the menu option m/ft.
Setting procedure:
• Press the
Zoom Ext
Select
ars on the display.
m/ft
AF-BEAM
• Select the „m/ft" menu option by pressing the
and
Set
highlighted.
• Confirm the selection of the special function by pres-
sing the
m
• Select the desired setting with the
keys. The setting takes effect immediately.
Set
F 4.5
A
m
AZoom 70
14 m
• Press the button
repeatedly until the display is reset to its normal state. If
the button
is not pressed, the display is automatically reset to its normal
view after about 5 seconds.
button repeatedly until „Select" appe-
Sel
keys. The selected menu option will be
button.
Set
and
- When „m" is displayed, distances will be
shown in meters.
- When „ft" is displayed, distances will be
shown in feet.

7.9 Secondary reflector

The secondary reflector i is used for frontal brightening in the case of indirect
lighting when the main reflector is pivoted to the side or upwards (see 10.3).
If the secondary reflector
produces too much light, it can be reduced to 1/2
or 1/4 .
• „
Off" setting: Secondary reflector is turned off.
• „
P1 / 1" setting: secondary reflector is operating at full light output.
• „
P1 / 2" setting: secondary reflector is operating at 1/2 light output.
• „
P1 / 4" setting: secondary reflector is operating at 1/4 light output.
When the secondary reflector is activated and the setting is saved, a symbol
will appear in the display.
Setting procedure:
• Press the
button repeatedly until „Select"
Sel
appears on the display.
• Select the menu option
by pressing the
keys. The selected menu option will be highligh-
ted.
• Confirm the selection of the special function by pres-
sing the
button.
Set
• Select the desired setting with the
keys. The setting takes effect immediately.
• Press the button
repeatedly until the display is
reset to its normal state. If the button
sed, the display is automatically reset to its normal
view after about 5 seconds.
Please also refer to the information in
Section 10.3!
Select
Beep
Mode
Para
Sel
and
1/1
and
Set
is not pres-
F 4.5
A
AZoom 70
14 m
131

Publicidad

Tabla de contenido
loading

Tabla de contenido