Switching The Remote Flash Mode On And Off; Settings On The Master Flash Unit - Metz MECABLITZ 58 AF-2 digital Manual De Instrucciones

19.1 Switching the remote flash mode on and off

• Press the
BEEP
Select
on the display.
Remote
FB
• Use the
Set
the menu. The selected menu option will be indicated
by a dark bar.
Remote
• Press the
Master
"Remote".
Set
• Use the
Master"
for slave operation, or "Remote OFF" to deactivate
remote flash mode.
The setting is effective immediately.
CH1
M
• Press
A
TTL
AZoom 28
mal reading. If the
B 1
TTL+ /
F32
3
will switch back to normal automatically after appro-
Para Sel
ximately 5 seconds.
key repeatedly until "Select" appears
Sel
and keys to select "Remote" from
key to confirm the selection of
Set
and keys to select "Remote
for master operation, "Remote Slave"
repeatedly to return the display to its nor-
key is not pressed, the display

19.2 Settings on the master flash unit

☞ Slave groups A and B are always activated. They cannot be deactivated.
The master flash unit M and slave group C can be activated or deactiva-
ted, however. If the master flash unit is deactivated, it only controls the
slave units and does not contribute to exposing the shot
The key can be used to sequentially access the settings for the master flash
Para
unit M and the slave flash units in groups A, B, and C.
Canon E-TTL remote
Adjusting the settings for slave group A
• Press the key repeatedly until "A" (for slave group A) appears on the LC
Para
display.
• While A is displayed, press the
appears in the display next to the A.
–
• While A TTL is displayed, the
flash exposure correction value for the slave flash units in group A, from -3 f-
stops (EV) to +3 f-stops (EV) in 1/3 increments.
• Press to save your settings. If the
saved automatically after approximately 5 seconds.
Adjusting the settings for slave group B
• Press the key repeatedly until B TTL (for slave group B) appears on the
Para
LC display.
–
• While B TTL is displayed, the
flash exposure correction value for the slave flash units in group B, from -3 f-
stops (EV) to +3 f-stops (EV) in 1/3 increments.
• Press to save your settings. If the key
saved automatically after approximately 5 seconds.
key repeatedly until TTL (E-TTL remote)
Mode
+
and keys can be used to adjust the
key is not pressed, the settings will be
+
and keys can be used to adjust the
is not pressed, the settings will be
141