1Reactivating The Af Measuring Beam; Meter-Feet Changeover (M - Ft); Resetting The Flash Unit's Settings - Metz MECABLITZ 28 AF-3 digital Manual De Instrucciones

6.1.1 Reactivating the AF measuring beam
• Switch off the flash unit.
• Keep the "MODE" key and the manual firing
button depressed.
• Switch on the flash unit.
• "AF / On" is indicated on the display.
The flash unit's AF-measuring beam is only
switched on if this function is supported by
the camera.

6.2 Meter-feet changeover (m - ft)

Proceed in the following manner to change
between m / ft:
• Turn off the flash unit by its main switch.
• Keep the "ZOOM" key depressed.
• Turn on the flash unit by its main switch.
• Release the pre-select key.
The display changes from "m" to "ft" or from "ft"
to "m". The selected unit of measurement is re-
tained after the flash unit has been switched off or
the batteries have been exchanged.

6.3 Resetting the flash unit's settings

• Switch on the flash unit by its main switch.
• Keep the "MODE" button depressed for about
5 sec.
The following settings are set:
• The AF measuring beam is activated.
• The reflector status is set at 35 mm illumination
without reflector attachment.
• Distance indication is set to "m".
• The TTL flash mode is activated.
101