Adjusting The Speaker Output Levels; Before You Begin; Test Dolby Sur - Yamaha DSP-AZ2 Manual De Instrucciones

ADJUSTING THE SPEAKER OUTPUT LEVELS

This section explains how to adjust the speaker output
levels by using the test tone generator. The "TEST
DOLBY SUR." is for balancing the output levels of the
six speakers required for surround sound systems. The
"TEST DSP" is for balancing the front effect speakers
with the main speakers for the DSP sound field programs.
When this adjustment is made, the output level heard at
the listening position will be the same from each speaker.
This is important for the best performance of the digital
sound field processor, and various decoders (Dolby
Digital, Dolby Pro Logic, Dolby Pro Logic , DTS, DTS
ES, and DTS Neo: 6).
The adjustment of each speaker output level should be
made at your listening position with the remote control.
Note
• Since this unit cannot enter the test mode while headphones are
connected to this unit, be sure to unplug the headphones from
the PHONES jack when using the test tone.

Before You Begin

NATURAL SOUND AV AMPLIFIER DSP-AZ2
STANDBY
/ON
INPUT MODE
SPEAKERS
A B
SOURCE
DVD
D–TV/LD
SILENT
CBL/SAT
VCR 1
BASS PROCESSOR
VCR2
EXTENSION DIRECT
/DVR
PHONES
V–AUX
– + – +
REC OUT
BASS TREBLE
2 3 3
A/B/C/D/E PRESET
TV INPUT
TV VOL CH
TV MUTE
DISC
ON SCREEN
LEVEL
SLEEP TEST
1
Turn on the video monitor connected to this
unit.
2
Press SPEAKERS A or B
to select the main
speakers to be used.
If you are using two sets of the
main speakers, press both A
and B.
VOLUME
D I G I T A L
NEXT – SET MENU +
MD/TAPE
CD–R
TUNER
CD
S VIDEO VIDEO L AUDIO R OPTICAL
6CH
PHONO STEREO PROGRAM INPUT
EFFECT
VIDEO AUX
MUTE
VOLUME
STEREO
EFFECT
4
PARAMETER
SET MENU
SPEAKERS
A B
3
Set the BASS and TREBLE controls on the
front panel to the center position and turn off
BASS EXTENSION and PROCESSOR
DIRECT by pressing the buttons.
"BASS EXT. OFF" and "P. DIRECT OFF" appear
on the front panel display.
– + – +
BASS TREBLE
4
Set PARAMETER/SET
MENU on the remote
control to PARAMETER.

TEST DOLBY SUR.

Select "TEST DOLBY SUR." to match the output levels
of the center, rear center and left and right rear speakers
to the left and right main speakers.
A/B/C/D/E
TV INPUT
TV VOL
TV MUTE
ON SCREEN LEVEL
SLEEP TEST
1, 4
1
Press TEST to output the
test tone.
2
Adjust the volume so you can hear the test
tone.
VOLUME
BASS PROCESSOR
EXTENSION DIRECT
Set to OFF.
PARAMETER
SET MENU
PRESET
2
MUTE
CH VOLUME
STEREO
DISC EFFECT
PARAMETER
SET MENU
3
TEST
25