Yamaha DSP-AZ2 Manual De Instrucciones página 48

REMOTE CONTROL FEATURES
I Operating the macro
TRANSMIT RE-NAME CLEAR LEARN
SYSTEM
A
POWER STANDBY
V-AUX TUNER MD/TAPE
D-TV/LD CBL/SAT VCR 1
1
Set MACRO ON/OFF to ON.
2
Press a macro button.
Notes
• When you have finished using the Macro feature, set MACRO
ON/OFF to OFF.
• While this unit is carrying out a macro program, this unit does
not receive any other button's function until the macro
operation has been completed (the TRANSMIT indicator stops
flashing).
• Continue to aim the remote control at the component the macro
is operating until the macro operation has been completed.
I Programming a macro
You can program your own macros and use the Macro
feature to transmit many remote control commands by
pressing a single button.
Notes
• The factory-set macro is not cleared when a new macro is
programmed for a button. The factory-set macro can be used
again when the programmed macro is cleared.
• It is not possible to add a new signal (macro step) to the
factory-set macro. Programming a macro changes all macro
contents.
• A macro programming is used to transmit learning or setup (or
YAMAHA preset) button signals of this remote control to a
macro button. If necessary, set up the manufacturer code or
program a function with the remote control for your
component.
• This remote control handles button signals that operate
continuously, such as volume control, as short time interval
codes. Macro programming that include these types of macro
steps are therefore not recommended.
1
Press MACRO by using a ballpoint pen or
similar object.
"MCR ?" appears in the display window.
MACRO
Note
• Complete each of the following steps in 30 seconds. Otherwise,
the learning mode will be automatically canceled. In this case,
press MACRO again.
46
MACRO
MACRO
MACRO ON/OFF
MACRO OFF ON
B
PHONO
CD-R CD
Macro buttons
VCR2/DVR DVD
2
Press a macro button for which you want to
program the macro operation.
The button you chose for programming the macro
operation and the selected component name appear
alternately in the display window.
SYSTEM
A B
POWER STANDBY PHONO
V-AUX TUNER MD/TAPE CD-R CD
D-TV/LD CBL/SAT VCR 1 VCR2/DVR DVD
Note
• "AGAIN" appears in the display window when a button other
than the macro buttons is pressed.
3
Press the buttons of the functions that you
want to include in the macro operation
sequence in order.
y
• You can set up to 10 steps (10 functions). After you have set 10
steps, "FULL" appears and the remote control automatically
exits from the macro mode.
SYSTEM
A
STANDBY
POWER
V-AUX TUNER MD/TAPE
D-TV/LD CBL/SAT VCR 1 VCR2/DVR
TITLE
SOURCE
DISPLAY MENU
SELECT
SEARCH
POWER REC STOP
appear alternately so that you can
set up the next step
Notes
• "NG" appears in the display window when programming has
not been done correctly. In this case, start over from step 2.
• If you want to change the source component, use SOURCE
SELECT k / n. When you use the input selector buttons,
selecting the input is programmed as a macro step, whereas
SOURCE SELECT k / n only changes the component.
B
PHONO
CD-R CD
DVD
6CH INPUT
ENTER
SOUND
– +
CHAPTER
1
PAUSE PLAY
MCR 1 : DVD a
2
MCR 2 : DVD p
indicate the number
of macro steps you
entered