Clearing A Learned Function; Clearing A Macro Function - Yamaha DSP-AZ2 Manual De Instrucciones

REMOTE CONTROL FEATURES

Clearing a Learned Function

You can clear the function learned in a certain
programmable button in each area.
1 Press an input selector button, Å or ı to
select the source component you want to
clear the function.
The selected component name appears in the display
window.
A B
PHONO
V-AUX TUNER MD/TAPE CD-R CD
D-TV/LD CBL/SAT VCR 1 VCR2/DVR DVD
2
Press LEARN by using a ballpoint pen or
similar object.
"LEARN" and the selected component name appear
alternately in the display window.
LEARN
Note
• Complete each of the following steps in 30 seconds. Otherwise
the learning mode will be automatically canceled. In this case,
press LEARN again.
3
Press and hold CLEAR by using a ballpoint
pen or similar object, then press the button
for which you want to clear the function for
about 3 seconds.
"C:OK" appears in the display window.
MACRO
TRANSMIT RE-NAME CLEAR LEARN MACRO OFF ON
SYSTEM
A B
POWER STANDBY PHONO
V-AUX TUNER MD/TAPE CD-R CD
D-TV/LD CBL/SAT VCR 1 VCR2/DVR DVD
y
• You can clear other learned functions at this time by holding
down CLEAR again and pressing the other buttons for which
those learned functions have been programmed.
Note
• "C:NG" appears in the display window if the operation is
unsuccessful. In this case, try step 3 again.
4
Press LEARN again to
exit.
Once you have cleared a learned function for a
button, the button reverts to the factory setting.
48

Clearing a Macro Function

1
Press MACRO to clear a programmed macro
by using a ballpoint pen or similar object.
MACRO
Note
• Complete each of the following steps in 30 seconds. Otherwise
the learning mode will be automatically canceled. In this case,
press MACRO again.
2
Press and hold CLEAR by using a ballpoint
pen or similar object, then press the button
for which you want to clear the macro for
about 3 seconds.
"C:OK" appears in the display window.
TRANSMIT
SYSTEM
POWER
V-AUX
D-TV/LD CBL/SAT
y
• You can clear other macros at this time by holding down
CLEAR again and pressing the other buttons for which those
macros have been programmed.
Note
• "C:NG" appears in the display window if the operation is
unsuccessful. In this case, try step 2 again.
3
Press MACRO again to exit from the clearing
mode.
Once you have cleared macro for a button, the button
reverts to the factory setting.
LEARN
MACRO
RE-NAME CLEAR LEARN MACRO OFF ON
A B
STANDBY PHONO
TUNER MD/TAPE CD-R CD
VCR 1 VCR2/DVR DVD
MACRO