To Assemble And Disassemble The Weights - Husqvarna PG 690 Manual Del Usuario

position is also used when you set the product in
transport position.
• Position 2: Standard pressure on the grinding head.
• Position 3: Minimum pressure on the grinding head.
This position is also used when you tilt the product to
servicing position.

To assemble and disassemble the weights

The product has 1 weight on each side of the product.
Do the procedure that follows on each weight.
32
1. Install the weight holder and tighten the 4 screws.
2. Install the 2 weight brackets. Make sure that the
weight brackets are installed correctly as shown in
the illustration.
3. Put the weight on the cylinder (A) on the weight
holder.
A
B
1163 - 003 - 22.01.2020