To Assemble And Disassemble The Weights - Husqvarna PG 690 Propane Manual Del Usuario

6. Turn the main switch counterclockwise.
Weights
The product has 1 weight on each side of the product. If
the product is heavy to operate, adjust the weights to
change the pressure on the grinding head. The weights
must be adjusted to the same position on the right and
the left side. The weights has 3 positions:
• Position 1: Maximum pressure on the grinding head.
This position increases the operation effect. This
position is also used when you set the product in
transport position.
• Position 2: Standard pressure on the grinding head.
18
• Position 3: Minimum pressure on the grinding head.
This position is also used when you tilt the product to
servicing position.

To assemble and disassemble the weights

The product has 1 weight on each side of the product.
Do the procedure that follows on each weight.
1. Install the weight holder and tighten the 4 screws.
2. Install the 2 weight brackets. Make sure that the
weight brackets are installed correctly as shown in
the illustration.
1212 - 003 - 25.05.2020